The TAS5342LA is a high-performance, integrated stereo digital amplifier power stage designed to drive a 4-Ω bridge-tied load (BTL) at up to 100 W per channel with low-harmonic distortion, low-integrated noise, and low-idle current.
●The TAS5342LA has a complete protection system integrated on-chip, safeguarding the device against a wide range of fault conditions that could damage the system. These protection features are short-circuit protection, over-current protection, under voltage protection, over temperature protection, and a loss of PWM signal (PWM activity detector).
●A power-on-reset (POR) circuit is used to eliminate power-supply sequencing that is required for most power-stage designs.
● Total Power Output (Bridge Tied Load)
● 2 × 100 W at 10% THD+N Into 4 Ω
● 2 × 80 W at 10% THD+N Into 6 Ω
● 2 × 65 W at 10% THD+N Into 8 Ω
● Total Power Output (Single Ended)
● 4 × 40 W at 10% THD+N Into 3 Ω
● 4 × 30 W at 10% THD+N Into 4 Ω
● Total Power Output (Parallel Mode)
● 1 × 200 W at 10% THD+N Into 2 Ω
● 1 × 160 W at 10% THD+N Into 3 Ω
● >110 dB SNR (A-Weighted With TAS5518 Modulator)
● <0.1% THD+N (1 W, 1 kHz)
● Supports PWM Frame Rates of 192 kHz to 432 kHz
● Resistor-Programmable Current Limit
● Integrated Self-Protection Circuitry, Including:
● Under Voltage Protection
● Overtemperature Warning and Error
● Overload Protection
● Short-Circuit Protection
● PWM Activity Detector
● Standalone Protection Recovery
● Power-On Reset (POR) to Eliminate System Power-Supply Sequencing
● High-Efficiency Power Stage (>90%) With 110-mΩ Output MOSFETs
● Thermally Enhanced Package 44-Pin HTSSOP (DDV)
● Error Reporting, 3.3-V and 5-V Compliant
● EMI Compliant When Used With Recommended System Design
