The STM8S001J3 8-bit microcontrollers offer 8 Kbytes of Flash program memory, plus integrated true data EEPROM. It is referred to as low-density device in the STM8S microcontroller family reference manual (RM0016).
●The STM8S001J3 device provides the following benefits: performance, robustness and reduced system cost.
●Device performance and robustness are ensured by true data EEPROM supporting up to 100000 write/erase cycles, advanced core and peripherals made in a state-of-the-art technology at 16 MHz clock frequency, robust I/Os, independent watchdogs with separate clock source, and a clock security system.
●The system cost is reduced thanks to a high system integration level with internal clock oscillators, watchdog, and brown-out reset.
●Full documentation is offered as well as a wide choice of development tools.
●Key Features
● Core
● 16 MHz advanced STM8 core with Harvard architecture and 3-stage pipeline
● Extended instruction set
● Memories
● Program memory: 8 Kbytes Flash memory; data retention 20 years at 55 °C after 100 cycles
● RAM: 1 Kbyte
● Data memory: 128-byte true data EEPROM; endurance up to 100 k write/erase cycles
● Clock, reset and supply management
● 2.95 V to 5.5 V operating voltage
● Flexible clock control, 3 master clock sources
● External clock input
● Internal, user-trimmable 16 MHz RC
● Internal low-power 128 kHz RC
● Clock security system with clock monitor
● Power management
● Low-power modes (wait, active-halt, halt)
● Switch-off peripheral clocks individually
● Permanently active, low-consumption power-on and power-down reset
● Interrupt management
● Nested interrupt controller with 32 interrupts
● Up to 5 external interrupts
● Timers
● Advanced control timer: 16-bit, 2 CAPCOM channels, 2 outputs, dead-time insertion and flexible synchronization
● 16-bit general purpose timer, with 3 CAPCOM channels (IC, OC or PWM)
● 8-bit basic timer with 8-bit prescaler
● Auto wakeup timer
● Window and independent watchdog timers
● Communications interfaces
● UART, SmartCard, IrDA, LIN master mode
● SPI unidirectional interface up to 8 Mbit/s (master simplex mode, slave receiver only)
● I2C interface up to 400 Kbit/s
● Analog to digital converter (ADC)
● 10-bit ADC, ± 1 LSB ADC with up to 3 multiplexed channels, scan mode and analog watchdog
● I/Os
● Up to 5 I/Os including 4 high-sink outputs
● Highly robust I/O design, immune against current injection
● Development support
● Embedded single-wire interface module (SWIM) or fast on-chip programming and non-intrusive debugging
