The STM32F303RCT7 is a STM32 F3 series 32-bit Microcontroller incorporates the high-performance ARM Cortex-M4 RISC core operating at a frequency of up to 72MHz and embedding a floating point unit (FPU), high-speed embedded memories (Flash memory up to 256kB and 48kB of SRAM) and an extensive range of enhanced I/Os and peripherals connected to two APB buses. The device offer a fast 12-bit ADCs, seven comparators, four operational amplifiers, two DAC channels, five general-purpose 16-bit timers, one general-purpose 32-bit timer, as well as standard and advanced communication interfaces - two I²Cs, three SPIs, two I²Ss, three USARTs, two UART, a CAN and an USB FS device.
● CRC calculation unit
● Power-on/Power-down reset (POR/PDR)
● Programmable voltage detector (PVD)
● Low-power modes - Sleep, stop, standby
● VBAT supply for RTC and backup registers
● 4 to 32MHz Crystal oscillator
● 32kHz Oscillator for RTC with calibration
● 8MHz Internal RC with x 16 PLL option
● 40kHz Internal oscillator
● Interconnect matrix
● 12-channel DMA Controller
● 2 x Watchdog timers (Independent and window)
● SysTick Timer
● Two 16-bit Basic timers to drive the DAC
● Calendar RTC with alarm, periodic wakeup from Stop/Standby
● CAN interface (2.0B Active)
● USB 2.0 full speed interface
● Infrared transmitter
● Serial wire debug
● 96-bit Unique ID
