The MSP430F5510IPT is a 16-bit ultra-low-power Mixed-signal Microcontroller features a powerful 16-bit RISC MSP430 CPU, 16-bit registers and constant generators that contribute to maximum code efficiency. The architecture combined with five low-power modes, is optimized to achieve extended battery life. The digitally controlled oscillator (DCO) allows wake-up from low-power modes to active mode in less than 5µs. The device configurations with four 16-bit timer, 10-bit A/D converter, two universal serial communication interfaces (USCIs), three-channel internal DMA, a 8-channel comparator, a 32-bit hardware multiplier and 47 general-purpose I/O pins. This device operates at a maximum frequency of 25MHz.
● 16-bit RISC architecture, extended memory, up to 25MHz system clock
● Fully integrated LDO with programmable regulated core supply voltage
● Supply voltage supervision, monitoring and brownout
● FLL Control loop for frequency stabilization
● Low-power low-frequency internal clock source (VLO)
● Low-frequency trimmed internal reference source (REFO)
● 32kHz Watch crystals (XT1)
● High-frequency crystals up to 32MHz (XT2)
● 16-bit Timer TA0, Timer_A with five Capture/Compare registers
● 16-bit Timer TA1, Timer_A with three Capture/Compare registers
● 16-bit Timer TA2, Timer_A with three Capture/Compare registers
● 16-bit Timer TB0, Timer_B with seven Capture/Compare shadow registers
● Enhanced UART supports auto-baudrate detection
● IrDA Encoder and decoder
● Synchronous SPI
● Full-speed USB - integrated USB-PHY, 3.3V and 1.8V USB power system, USB-PLL, 8 I/O endpoints
● 10-bit ADC with window comparator
● Serial on-board programming
● No external programming voltage needed
● Basic timer with RTC
