MSP430F2274 Datasheet PDF - TI

The Texas Instruments MSP430 family of ultra-low-power microcontrollers consist of several devices featuring different sets of peripherals targeted for various applications. The architecture, combined with five low-power modes is optimized to achieve extended battery life in portable measurement applications. The device features a powerful 16-bit RISC CPU, 16-bit registers, and constant generators that contribute to maximum code efficiency. The digitally controlled oscillator (DCO) allows wake-up from low-power modes to active mode in less than 1 µs.

●The MSP430F22x4/MSP430F22x2 series is an ultra-low-power mixed signal microcontroller with two built-in 16-bit timers, a universal serial communication interface, 10-bit A/D converter with integrated reference and data transfer controller (DTC), two general-purpose operational amplifiers in the MSP430F22x4 devices, and 32 I/O pins.

●Typical applications include sensor systems that capture analog signals, convert them to digital values, and then process the data for display or for transmission to a host system. Stand-alone radio-frequency (RF) sensor front ends are another area of application.

● Low Supply Voltage Range: 1.8 V to 3.6 V

● Ultra-Low Power Consumption

● Active Mode: 270 µA at 1 MHz, 2.2 V

● Standby Mode: 0.7 µA

● Off Mode (RAM Retention): 0.1 µA

● Ultra-Fast Wake-Up From Standby Mode in Less Than 1 µs

● 16-Bit RISC Architecture, 62.5-ns Instruction Cycle Time

● Basic Clock Module Configurations

● Internal Frequencies up to 16 MHz With Four Calibrated Frequencies to ±1%

● Internal Very-Low-Power Low-Frequency Oscillator

● 32-kHz Crystal

● High-Frequency (HF) Crystal up to 16 MHz

● Resonator

● External Digital Clock Source

● External Resistor

● 16-Bit Timer_A With Three Capture/Compare Registers

● 16-Bit Timer_B With Three Capture/Compare Registers

● Universal Serial Communication Interface

● Enhanced UART Supporting Auto-Baudrate Detection (LIN)

● IrDA Encoder and Decoder

● Synchronous SPI

● I2C™

● 10-Bit 200-ksps Analog-to-Digital (A/D) Converter With Internal Reference, Sample-and-Hold, Autoscan, and Data Transfer Controller

● Two Configurable Operational Amplifiers (MSP430F22x4 Only)

● Brownout Detector

● Serial Onboard Programming, No External Programming Voltage Needed, Programmable Code Protection by Security Fuse

● Bootstrap Loader

● On-Chip Emulation Module

● Family Members Include:

● MSP430F2232: 8KB + 256B Flash Memory, 512B RAM

● MSP430F2252: 16KB + 256B Flash Memory, 512B RAM

● MSP430F2272: 32KB + 256B Flash Memory, 1KB RAM

● MSP430F2234: 8KB + 256B Flash Memory, 512B RAM

● MSP430F2254: 16KB + 256B Flash Memory, 512B RAM

● MSP430F2274: 32KB + 256B Flash Memory, 1KB RAM

● Available in a 38-Pin Thin Shrink Small-Outline Package (TSSOP) (DA), 40-Pin QFN Package (RHA), and 49-Pin Ball Grid Array Package (YFF)

● For Complete Module Descriptions, See the (SLAU144)

●All trademarks are the property of their respective owners.