The ISO5452DWR is a reinforced Isolated Gate Driver for IGBTs and MOSFETs with split outputs, OUTH and OUTL, providing 2.5A source and 5A sink current. The input side operates from a single 2.25 to 5.5V supply. The output side allows for a supply range from minimum 15V to maximum 30V. Two complementary CMOS inputs control the output state of the gate driver. The short propagation time of 76ns assures accurate control of the output stage. An internal desaturation (DESAT) fault detection recognizes when the IGBT is in an overcurrent condition. Upon a DESAT detect, a mute logic immediately blocks the output of the isolator and initiates a soft-turn-OFF procedure which disables, OUTH and pulls OUTL to low over a time span of 2µs. When OUTL reaches 2V with respect to the most negative supply potential, VEE2, the gate driver output is pulled hard to VEE2 potential turning the IGBT immediately off.
● Output short-circuit clamp
● Soft turn-OFF (STO) during short-circuit
● Fault alarm upon desaturation detection is signalled on FLT and reset through RST
● Input and output under-voltage lock-out (UVLO) with ready (RDY) pin indication
● Active output pull-down and default low outputs with low supply or floating inputs
● CMOS compatible input
● Rejects input pulses and noise transients shorter than 20ns
● 2A Active miller clamp
● 15 to 30V Output driver supply voltage
● 10000VPK (according to IEC 61000-4-5) Surge immunity
● Green product and no Sb/Br
