C8051F363-GQ Datasheet PDF - Silicon Labs

System Overview

●C8051F36x devices are fully integrated mixed-signal System-on-a-Chip MCUs. Highlighted features are listed below. Refer to Table 1.1for specific product feature selection.

●• High-speed pipelined 8051-compatible microcontroller core (up to 100 MIPS)

●• In-system, full-speed, non-intrusive debug interface (on-chip)

●• True 10-bit 200 ksps 16-channel single-ended/differential ADC with analog multiplexer

●• 10-bit Current Output DAC

●• 2-cycle 16 by 16 Multiply and Accumulate Engine

●• Precision programmable 25 MHz internal oscillator

●• Up to 32 kB of on-chip Flash memory—1024 bytes are reserved

●• 1024 bytes of on-chip RAM

●• External Data Memory Interface with 64 kB address space

●• SMBus/I2C, Enhanced UART, and Enhanced SPI serial interfaces implemented in hardware

●• Four general-purpose 16-bit timers

●• Programmable Counter/Timer Array (PCA) with six capture/compare modules and Watchdog Timer function

●• On-chip Power-On Reset, VDDMonitor, and Temperature Sensor

●• Two on-chip Voltage Comparators

●• up to 39 Port I/O (5 V tolerant)

●Analog Peripherals

●\- 10-Bit ADC (‘F360/1/2/6/7/8/9 only)

●• Up to 200 ksps

●• Up to 21 external single-ended or differential inputs

●• VREF from internal VREF, external pin or VDD

●• Internal or external start of conversion source

●• Built-in temperature sensor

●\- 10-Bit Current Output DAC (‘F360/1/2/6/7/8/9 only)

●\- Two Comparators

●• Programmable hysteresis and response time

●• Configurable as interrupt or reset source

●• Low current (0.4 µA)

●\- Brown-out detector and POR Circuitry

●On-Chip Debug

●\- On-chip debug circuitry facilitates full speed, non intrusive in-system debug (no emulator required)

●\- Provides breakpoints, single stepping, inspect/modify memory and registers

●\- Superior performance to emulation systems using ICE-chips, target pods, and sockets

●\- Low cost, completedevelopment kit

●Supply Voltage

●\- Range: 2.7–3.6 V (50 MIPS) 3.0–3.6 V (100 MIPS)

●\- Power saving suspend and shutdown modes

●High Speed 8051 µC Core

●\- Pipelined instruction architecture; executes 70% of instructions in 1 or 2 system clocks

●\- 100 MIPS or 50 MIPS throughput with on-chip PLL

●\- Expanded interrupt handler

●\- 2-cycle 16 x 16 MAC engine

●Memory

●\- 1280 bytes internal data RAM (256 + 1024)

●\- 32 kB (‘F360/1/2/3/4/5/6/7) or 16 kB (‘F368/9) Flash;

●   In-system programmable in 1024-byte Sectors—

●   1024 bytes are reserved in the 32 kB devices

●Digital Peripherals

●\- up to 39 Port I/O; All 5 V tolerant with high sink current

●\- Hardware enhanced UART, SMBus™, and enhanced SPI™ serial ports

●\- Four general purpose 16-bit counter/timers

●\- 16-Bit programmable counter array (PCA) with six capture/compare modules

●\- Real time clock mode using PCA or timer and external clock source

●\- External Memory Interface (EMIF)

●Clock Sources

●\- Two internal oscillators:

●• 24.5 MHz with ±2% accuracy supports crystal-less UART operation

●• 80/40/20/10 kHz low frequency, low power

●\- Flexible PLL technology

●\- External oscillator: Crystal, RC, C, or clock (1 or 2 pin modes)

●\- Can switch between clock sources on-the-fly; useful in power saving modes

●Packages

●\- 48-pin TQFP (C8051F360/3)

●\- 32-pin LQFP (C8051F361/4/6/8)

●\- 28-pin QFN (C8051F362/5/7/9)

●Temperature Range: –40 to +85 °C